LumiLor

What do you need to get started with LumiLor?

What skills or experience are needed to apply LumiLor?

LumiLor is applied using a HVLP (high volume, low pressure) spray gun. Basic painting skills such substrate preparation, masking, etc. are required.   Painters with experience  applying coatings with a HVLP system have the basic skills needed to apply LumiLor.
LumiLor sprays similarly to other paints.  Always remember that when applying LumiLor you are constructing an electrical system that must have specific properties to work correctly.  Meticulously following the instructions is required instead of relying on visual queues.
Three to five hours is needed to apply all of the layers of LumiLor in standard conditions. LumiLor should be applied in an ambient temperature of at least 70 degrees Fahrenheit.

What equipment do I need to apply LumiLor?

REQUIRED items for applying LumiLor
  • Multimeter
    • Must have the ability to read ohms and mega-ohms.  
    • Amp reading may be useful but is not required.
  • Black light
    • Any size/shape of blacklight can be used - handheld flashlights (you will need someone to hold it for you), miners light/headlamp, wands/tubes, cannons, etc.  
    • Larger black lights illuminate more workable area. 
    • Portable black lights allow for flexibility in pointing the light where needed. 
  • Camera/video recorder and notebook to document your progress.
    • Detailed visual documentation is essential for troubleshooting application issues.
  • Automotive grade HVLP gravity fed spray guns with 1.3mm nozzle
  • Paint Preparation System (PPS) with attachments - to allow spray gun to be stored upside down while not in use and will help to avoid clogging the nozzle with heavy particles 
    • Hard shell cup, disposable sleeves, screw top lid
    • Fitting attachment (each brand of spray gun has different fittings, please check for proper fittings)
    • Watch the video at the bottom of this page highlighting the importance of using a PPS.
  • Speed clear - A quality 2K speed clear system is recommended.  Never use a low quality clear coat over LumiLor as it has a chance of damaging the Conductive Top Coat.
  • Automotive grade clear coat
  • Infrared heat gun 500° - 650° Fahrenheit
  • Stir sticks - glass or plastic (no metal or wood)
  • Red Scotch Brite pads 320-400 grit
  • 97% isopropyl alcohol
  • Fine line tape 1/2" 
  • Masking tape 3/4" and 1/4"
  • Masking paper 3"
  • Drill or Dremel with 3/32" bit (not required for 2oz Starter Kit)
  • Strainers: 120-140 micron
  • Mixing cups: 8oz or 32oz
  • Tack rags
  • Touch up brush pack - various sizes
  • Well ventilated area
  • Compressor, airlines and fittings
  • Respirator
  • Nitrile gloves

RECOMMENDED items for applying LumiLor
  • Spray suit
  • Paint stand and cart
  • Popsicle sticks 
  • Mixing plate
  • 2 wash bottles (alcohol/thinner )
  • Heat lamps and stand
  • UV goggles (when using blacklight)
View as
per page
Picture of Inverter-KPTA-0144-18(5 pack)

Inverter-KPTA-0144-18(5 pack)

Inverter-KPTA-0144-18(5 pack)
$65.00